DIY: Akebono BBK Installation on 03-07 G/Z
#106
Registered User
iTrader: (5)
Here is a cheaper option you might want to consider:
http://infiniti.sewellparts.com/acce...2004/4659.html
I just installed them with my Akebono BBK today, and will test them out tomorrow.
http://infiniti.sewellparts.com/acce...2004/4659.html
I just installed them with my Akebono BBK today, and will test them out tomorrow.
#108
Registered User
iTrader: (5)
I'd never really worked on a car and i had to install spacers so it took me a good 12 hours. I would say do it with a strong friend and a breaker bar or if you had an impact wrench you could probably knock it out in 6 hours for sure. Just lay everything out and a have a good plan of attack.
#111
Easily done in a day. If everything is set up, 4-5 hours. I have an FX so no shields to cut nor brackets to install, but I did the fronts in a little over 1 hour. I used a cheap electric impact gun since getting a breaker bar into the wheel well is troublesome.
Just do the fronts first, then rears. That way if it runs long you can just drive it around until you have time to finish.
Just do the fronts first, then rears. That way if it runs long you can just drive it around until you have time to finish.
#112
Fueled Racing brackets
Hey guys,
Here is a pic of the Fueled Racing brackets I received the other day. These are SWEET !!!
http://www.fueledracing.com
I'm 1 step closer to actually doing the BBK conversion!
Here is a pic of the Fueled Racing brackets I received the other day. These are SWEET !!!
http://www.fueledracing.com
I'm 1 step closer to actually doing the BBK conversion!
The following users liked this post:
TunerMax (05-20-2014)
#114
Here is the kit---> http://www.z1motorsports.com/350_g35...oducts_id=4626
#117
This is where I got mine http://infiniti.sewellparts.com/acce...2004/4659.html
#119
Awesome ordered brackets last night so this conversion will be started soon. I called in to get prices on rotors and we need them off a 370z or g37s I'm assuming rwd option but it's giving me a L and R at the end of part number to tell me which side. Are they directional rotors when we do this mod?