yepppppp, will post it in less than 5min.

 

hurrrrry!!!

 

POSTED

https://g35driver.com/forums/brakes-suspension/147656-circuit-sports-stut-bar-review.html

 

thank youuuuu!

 

Just ordered it! Damn wish there wasn't traffic going that way or else I would've picked it up myself and saved $20!

 

Just ordered one, I have a 03 coupe with a 5/16 spacer and the stillen ca. Should fit without the engine cover.

 

I ordered one as well... It should be here tomorrow... I have the Vortech SC and a SSV... I will let ya all know how fitment is.

 

can you still adjust the shock or do you have to remove the bar each time?

 

here's mine on the crawford

https://g35driver.com/forums/brakes-suspension/147912-circuit-sport-strut-bar-crawford-plenum.html

 

Does it look like there's enough room to fit the adjusters for coilovers?

 

Depends on how much further the setup sticks up vs oem shocks.







As a FYI I measured 1/2" of deflection at 100lbs of force, tried to measure twist, couldn't imagineer a bankable test jic oh well.

 

I checked out my edfc motors & it will clear the mounts of the bar. All that has to be done is to unplug the wiring to the motors, snake the wiring through the opening on the bottom of the bar, & then bolt it down. Still on the fence with this. I think I will wait one more month & just buy the arc bar.... but for all the guys with a similar setup this will fit.

 

So for us non engineer savvy people, is that good or bad? It seems to be quite a bit of deflection for only 100 lbs of force. Have you tried this bar out yet? Any initial impressions?

 

Hi

I found out after Randy help me took out the engine cover. I think the circuit strut bar will clear 5/16" and pushing 5/8" spacer and here are 2 pictures.

 

Has anyone actually installed it with a 5/16" spacer? Will it fit with the engine cover on? How about with the engine cover off?