FilaNJ, where in jersey are you? I had no issue installing mine, I don't mind helpin, where you at?

 

Which bolt is it? I had to tighten the bolts in a specific order, otherwise, the passenger frontmost nut won't go on. The rearmost passenger one had to be tightened to press the bar down enough to let the last one get started.

 

I'm having the same problem with mine. I can only get the outside and front bolts on. The rear bolts on both sides are too short -->> The plate is not sitting flush so I can't get the nut to bite the bolt. Damn!!
Since these bars are a solid one piece, manufacturing have to be perfect. I guess my wasn't. I dont' know if Phase2 will exchange it for me. Anyone??

 

would the bars get mixed up between the 350z and the g35 bar?

 

lots of vendors often assume all 350z parts fit the g35 as well. this, however, is in fact for the g35.

 

This fit great on mine... The only issue I had was removing the bolts to begin with. They were over TQ'd and I stripped a cpl of em... I replaced the bolts before installing the bar. That might be the answer, just buy replacement bolts from the dealer before you attempt the installation.

 

wow i love that blue.....yea i just ordered mine so hopefully its meant for the g35 and also fits

 

I ordered one about a month and a half ago and every time I check the status of my order, it says "This order is on hold". I think they are out of stock. I called them two weeks ago and they said they didn't know when they get the next shipment. I'm tempted to just cancel the order and buy the Ritchie bar. Anyone else run into the same problem?

 

Just ordered it the day before yesterday, and yesterday they shipped it !!? Come on they are so quick !!, just call them i`m sure there is another problem ?

 

on the circuitsports website there is a carbon fiber bar for the Z. anyone know if they have one for the G?