Would this look homoz?
Joined: May 2005
Posts: 37,810
Likes: 585
From: ɐʍ 'ǝlʇʇɐǝs
Stuck on that stripped bolt? For the fronts I used airtools as much as I could but at about 9:00pm or so, I said forget it. Too loud and my compressor is loud as hell. So for the rears, I did them old school.
I'll tell ya. Having a big bench vice and having deep/1/2" drive sockets help. Along with having 2 doubles in wrench sizes like 17mm, 19mm, 14mm.
It was either last night or nothing. Tonight I have a dinner and tomorrow is a wedding reception.
I'll tell ya. Having a big bench vice and having deep/1/2" drive sockets help. Along with having 2 doubles in wrench sizes like 17mm, 19mm, 14mm.
It was either last night or nothing. Tonight I have a dinner and tomorrow is a wedding reception.
Originally Posted by Mixturepinoy
I can't wait to see it'
I'm still assed out. I have air tools at my inlaws home. so i may end up going there tonight
I'm still assed out. I have air tools at my inlaws home. so i may end up going there tonight
Originally Posted by Jeff92se
I have a full set of coupe/Z springs that I bought from Patrick.
P.S. homoz posts in this thread:
Originally Posted by :eek:
... I can do the rears in about 30 mins. If you want I can do the rears while you work on the fronts. . .
Originally Posted by :eek:
... I can get it to around 3" of the shaft showing and I don't think it bottomed out yet...
Joined: May 2005
Posts: 37,810
Likes: 585
From: ɐʍ 'ǝlʇʇɐǝs
You ARE showing up for the northgate pre-meet? 
Originally Posted by Drewer
Oh man! I woulda given you my OEM coupe springs just to clear up some room in my garage.
P.S. homoz posts in this thread:
P.S. homoz posts in this thread:
Joined: May 2005
Posts: 37,810
Likes: 585
From: ɐʍ 'ǝlʇʇɐǝs
Naw. If anything, I might run a full Z set so I could offer my coupes to someone. I dunno
Originally Posted by Drewer
Ya. . .you want 'em? I just posted up an "up for grabs" in the NW forum.
Joined: May 2005
Posts: 37,810
Likes: 585
From: ɐʍ 'ǝlʇʇɐǝs
What were you planning on doing?
Originally Posted by Mixturepinoy
Very nice improvement! That stud doesnt look like a big problem, i'm sure you'll be okay