If anybody else finds this and needs help with how to remove the old bushing and install the new one...

The first thing I did was ripped out the inner section of the lower bushing leaving a little rubber and the sleeve. A careful hacksaw will eventually cut a notch in the sleeve and then using a large socket that was the same size as the bushing I was able to easily hammer it out.

To install the new one I used a threaded rod along with a few sockets..
http://www.superstreetonline.com/how...d-replacement/

With the threaded rod with 2 bolts on one side and a socket on either side I was able to hit the thing with an air hammer until it pushed the bushing into the knuckle.