HELP: Rear suspension Install, Shock bolt sieze on bushing sleeve
Joined: Aug 2003
Posts: 660
Likes: 12
From: Ontario, Canada
HELP: Rear suspension Install, Shock bolt sieze on bushing sleeve
Hi all,
started installing my PSS10 coilovers and I have hit a wall. The rear shock bolt is seized onto the bushing sleeve. If I rotate the nut, it turns but only about 1/4 of a turn then snaps back because the bushin itself is turning and the sleeve is seized to it.
Need some help here - I have tried about a whole can of PB Blaster, heated the end of the nut, I'm using air tools with a 450FT LB impact gun and it won't budget. I'm plain out of ideas.
Anyone hit this before and have any good advice?
started installing my PSS10 coilovers and I have hit a wall. The rear shock bolt is seized onto the bushing sleeve. If I rotate the nut, it turns but only about 1/4 of a turn then snaps back because the bushin itself is turning and the sleeve is seized to it.
Need some help here - I have tried about a whole can of PB Blaster, heated the end of the nut, I'm using air tools with a 450FT LB impact gun and it won't budget. I'm plain out of ideas.
Anyone hit this before and have any good advice?
Thread
Thread Starter
Forum
Replies
Last Post
rezendvous420
G35 Sedan V35 2003-06
10
May 31, 2020 01:26 PM
kinetek
Brakes & Suspension
9
Aug 3, 2015 04:25 PM
