I'm hoping there are at least 20 in the picture

Now the trick will be to get them herded all into my car....

 

Cool Swivelhips, nice addition to your ride. Make sure to post the smile on your face after the install test run

 

I see harses wid no *****.

 

Nice, do you plan on just throwing it on or your going to clean it so it looks brand new?

 

Shweeeeet!

 

nice setup. is it the stillen 1st gen of that cbe??

 

Oh yeah Wayne!! The needle is now in the arm. Let the modding last forever.

 

Gen 2 - similar power, less noise. I put the Z-tube on from the CAI before running around for clamps and bolts, definitely creates some nice intake growl. Had no gaskets so I spent some time this aft fabbing some up from a sheet of gasket material. Not sure I'll get to the rest of the install this weekend, we'll see.

 

I'm afraid you might be right, Deane.

 

I think there is a set of OEM rays 19" coupe wheels in Stony Plain and we both know there is a Skunk II spacer in Sylvan Lake

 

^^ yeah, I see how it is...now the 'pushers' come out of the woodwork.

 

I KNOW I am right....from experience. Truth is though I've somehow resisted the temptation to continue.

Yep!!

 

The deed is DONE. Pictures later, and a sound clip if I can figure out how to make/post one. I have to admit, it's a bit louder than I expected, but sounds NICE, even a bit mean. Pretty quiet on the highway. The good part is, no rattles or leaks. It's actually a pretty clean installation and would not have taken as long had I just bitten the bullet and let down one side of the rear sway to start with. But I'm a stubborn old cuss, I reckon.

 

right on congrats!, i got the same stuff on my car and i love it!

 

Good on ya, Wayne. Can't wait to hear it if you can post a clip.