[DFW] What have you done to your G Today?
I adjusted my coilovers again, and uninstalled my front SPC camber arms. I think I am going to roll with the OEM front control arms.
I need to do some trimming on the rear fender liner due to some minor rubbing, but I will try and get it done tonight while I am still in the mood.
Anyone need some SPC front control arms for a 07+ sedan or G37?
I need to do some trimming on the rear fender liner due to some minor rubbing, but I will try and get it done tonight while I am still in the mood.
Anyone need some SPC front control arms for a 07+ sedan or G37?
The good.... I am all trimmed up, and don't really have any rubbing (there is a tad in the front on super big bumps, but the rear where it was bad is A-OK).
The bad.... I busted the bottom of a side skirt in the process, and dremeled the crap outta my arm with the cutting wheel; both felt great....
The plan for tomorrow.... lower the front a tad more (to match the rear and to get a little more negative camber to get rid of the rubbing), and fix the side skirt (it is about a 6-10" crack on the bottom, and I am going to try some JB Weld to fix it).
I will post some pics in a few days. I need to get the front a little lower (sorry, can't go as low as you...). Also,my car has not been washed since before CCM7 (which was in early July). I have been busy, and it has been collecting dust in my garage for the last few months (I probably have put 100 miles on my car in the last 2 months).
^^Yes it did - I took my time and I was lusting by the time I was done - pics dont do these brakes justice. They dwarfed the BREMBOS and fit PERFECT under his wheels. Jack was VERY patient...props to this setup and to Jack and to you Will since you made it happen... Preciate it buddy..
