Our Dipstick is retarded.
#46
While the position of the dipstick is annoying, surely I'm not the only that has figured out to put the thing back in without issue even in low light situations.
The trick is to use both hands. One hand on the puller and one the metal stick. Position the dipstick over top driver's side edge of the intake manifold, bend the dipstick slightly to create an arc, the start the dipstick at a slight angle (top towards the front bumper, tip pointing towards the back of the car). Position the tip into the slot, push a little, rotate the dipstick vertical while maintaining the slight arc and then push the stick down. It sounds complicated but works everytime without binding or getting stuck.
The trick is to use both hands. One hand on the puller and one the metal stick. Position the dipstick over top driver's side edge of the intake manifold, bend the dipstick slightly to create an arc, the start the dipstick at a slight angle (top towards the front bumper, tip pointing towards the back of the car). Position the tip into the slot, push a little, rotate the dipstick vertical while maintaining the slight arc and then push the stick down. It sounds complicated but works everytime without binding or getting stuck.
#47
#48
#50
Bump! Soo flustrated!!! I have no problems going in and out with the dipstick I just can never get s good reading lately, I used to get good ones all the time but after my last oil chance I can't!? I don't think its the oil.... had been using Mobil 1 syn. Up until my last change store was out of mobile1 so I chose Penzoil Plat I've pus several thousand miles on it and went to check it after driving from South Carolina to Virginia and can't get a reading its all up the stick but more oil on one side than the other I'm really perplexed
I read this whole thread and I'm lettingg the car sit for 30min after reaching operating temp, and still nada! I wana scream profanity froma mountain top
I read this whole thread and I'm lettingg the car sit for 30min after reaching operating temp, and still nada! I wana scream profanity froma mountain top
#51
Registered User
iTrader: (40)
^ thanks for bumping this.
i have got used to taking the dipstick in and out now.
it reads fine as well.
the only thing i dont like is, the small golden colored ramp around the dipstick enclosure always gets dirty as hell. i have to use a flashlight to put the dipstick back in, so that it doesnt touch the ramp.
maybe using compressed air to blow off all the dirt around the ramp might work.
i have got used to taking the dipstick in and out now.
it reads fine as well.
the only thing i dont like is, the small golden colored ramp around the dipstick enclosure always gets dirty as hell. i have to use a flashlight to put the dipstick back in, so that it doesnt touch the ramp.
maybe using compressed air to blow off all the dirt around the ramp might work.
#52
#53
#55
#56
Dipstick technique
I could only get my dipstick halfway in and after 30min if messing with it I realized I needed to use my 2nd hand to bend the middle section even more while I wiggle it all the way in . It's absurd this is necessary and I get oil all over my hands but at least it goes in every time now .
#57
Join Date: May 2017
Location: Washington State
Posts: 14,817
Received 2,467 Likes
on
2,159 Posts
Coupe 6MT Premium RAS
#58
I could only get my dipstick halfway in and after 30min if messing with it I realized I needed to use my 2nd hand to bend the middle section even more while I wiggle it all the way in . It's absurd this is necessary and I get oil all over my hands but at least it goes in every time now .
Thread
Thread Starter
Forum
Replies
Last Post
frankywashere
G35 Sedan V35 2003-06
7
08-31-2015 12:22 AM