I just installed the Injen SES and one tip seems to extend ~2" farther than the other tip.. I unbolted everything and aligned it and tightened it again and it doesn't really help much.. it also looks like the hanger is on the very edge of the rubber grommet, which is probably what's causing it to extend so far out.. anyone experience this before?

 

I am not really familiar with the pieces of the Injen, but Borla had specific parts for the left and right side that could be reversed if one weren't careful. Maybe its obvious, but I would double check to make sure all the parts are in the right place. If I am reading this right it doesn't sound like an alignment problem, there is no way it should be off that much.

DG/G 6MT coupe, Borla exhaust, Stillen intake w/Z tube, H-Tech, Hotchkis Sways, 19" TE-37's