Replaced driver side cam sensor, wont run
#1
Replaced driver side cam sensor, wont run
Hey guys, this is my first post so go easy.
So this morning I replaced my Bank 2 cam sensor because I was getting error code P1084, and it started. One thing I noticed however was that it took about 3-5 seconds longer to turn over and actually start than before. Didn't think anything of it.
Now when I drive it, it either wont start what so ever (even after ECU reset), or it will drive about 15 minutes and break down on me. I don't have any clue as to what's wrong with it or any know how of what to replace. Should I replace bank 1 also? Or should I try a different bank 2? The sensor I purchased was new.
Here is a video of what it sounds like:
(I know I probably shouldn't turn it that much but I was just trying to get an idea of the sound)
Any ideas would help a lot!
So this morning I replaced my Bank 2 cam sensor because I was getting error code P1084, and it started. One thing I noticed however was that it took about 3-5 seconds longer to turn over and actually start than before. Didn't think anything of it.
Now when I drive it, it either wont start what so ever (even after ECU reset), or it will drive about 15 minutes and break down on me. I don't have any clue as to what's wrong with it or any know how of what to replace. Should I replace bank 1 also? Or should I try a different bank 2? The sensor I purchased was new.
Here is a video of what it sounds like:
Any ideas would help a lot!
Thread
Thread Starter
Forum
Replies
Last Post
Homamk
Interior & Exterior
9
12-31-2016 07:39 PM