I am selling my MREV lower plenum as I switched to a Kinetix manifold, and no longer have a use for this. It was bought new, and on the car for probably 500 miles.
Asking $375
I have upper and lower gaskets as well that are included. Upper plenum and spacer are already gone.

 

I'm in need of some clarification. Is the MREV a stock lower plenum or an upgrade to a rev up? And, if it is an upgrade, do I still want a plenum spacer?

Thanks,

 

This is taken from Motordyne's website
"MREV 2 Manifold TM - The most powerful naturally aspirated bolt on you can put on your revup engine.

When used with or without a spacer or aftermarket upper plenum, this lower plenum will make substantial power gains. Multiple independent test show when used with a 5/16" spacer on the revup engine, the combination will add a "minimum" of 15+ HP and 18+ TQ in the upper midrange. Many independent MREV 2 Manifold REVUP tests have dynod in excess of 20HP and 30 TQ in the upper midrange and with high RPM peak power increased by 3-5 HP.

The MREV2 is a prerequisite to the plenum spacer when used on a revup engine. No other normally aspirated VQ modification provides as much gain as the MREV 2 Manifold!"

http://www.motordyneengineering.com/...f7147449849732

 

That certainly clarifies that. Thank you!

 

Bump

 

Where you located?

 

Wisconsin. I am willing to ship.

 

Bump

 

Bump

 

*shaking and rocking while scratching*

 

Just do it, you know you want it.

 

Still available? If so, I wanted to clarify that this is the MREV2 and not the MREV right?

Thanks!

 

Yes, it is still available and it is the Mrev2.

 

Sold!

 

Ho Ho nnoooo!!