Lighten your G with a Z1 1pc Aluminum Driveshaft, Crank pulley and Idler Delete!!!
#61
#64
#65
Ya. That sucks. You would think more companies would make this since everyone buys light crank pullies and flywheels. This is the only thing the g is lacking from the z. I contacted shaftmasters.com and they said they could make an aluminum one, they just need some measurements. Ill re post if i get them. Its about $400 as well
#67
The following users liked this post:
jimmyboi860 (09-18-2012)
#68
Hey sdgenius. Thanks but is your contact for aluminum driveshafts? I just got in contact with driveshaftspecialists.com and they stated " We have done some of these but have essentially taken them of the market. The largest tube that will fit is a 3.5" and at very high speeds the driveshaft rpm exceeds the critical speed of the tube. Then we have vibration issues and potential failure. Thanks for the inquiry though."
#71
#72
Hows it going everyone. Just throwing this out there if you get any word that the shipment came in post it! I will do the same as soon as I found out. Really want one of these