After the vortech...
#16
10-09-2006, 09:42 PM
Originally Posted by SWATSON
I have the stock vortech set up along with - Fluidampener crank pulley, 5/16" spacer, Strup headers, Crawford HFC, and HKS exhaust (no other mods) and i'm 355 rwhp. With the 3.12 pulley, you should deff. be up near 380 rwhp depending on your tune
u got a dyno sheet? I want to see what yours look like.
I think my tune was way too conservative. I'm hitting 10 on the aem wideband and I think it doesnt read anything lower than 10.0, lol. I'm thinking about just getting the 2.87 pulley and trying again for 380hp instead of going any leaner with the 3.12 pulley.
Last edited by Mr_pharmD; 10-09-2006 at 09:46 PM.
#17
10-10-2006, 02:23 AM
Hey swatson, does your pulley say 3.33 on it or is it blank? I purchased my kit used with an used 3.12 pulley but it doesnt say anything on it and I'm wondering if it's the actual size afterall. I am still able to see 8-9psi on the boost gauge but somehow u are also able to hit 8.7 with the 3.33 pulley?
Thread
Thread Starter
Forum
Replies
Last Post
GlenRoseFireFighter
Forced Induction
32
08-29-2005 04:14 PM
