6mt max whp rating
#16
Joined: Feb 2006
Posts: 13,068
Likes: 101
From: Southern Cali --> 818
360ish is probably an easier obtainable goal. i'm not sure why everyone's saying you need 10 grand to make a motor that powerful.... i've seen a vortech kit go for 2500 brand new from one of the vendors. install should be 1000-1500. tuning another 1000. so that's a bout 5 grand.
Even if it did run that low, lets do some numbers:
-Vortech tuner kit $2500
-Utech EMS $800
-Injectors + fuel pump $700
-Basic supporting mods which you will need to get to 360 whp on a Vortech ~$2000 (ie. exhaust, spacer, test pipes)
- Gauges (a must for forced induction) $1000+
- Tune $600+
- Installation $1000+
And these are all very conservative prices. Doing everything right needs $$$. If he really has great hookups, then that's great for him. But ballpark range for F.I is always 8-10k without doing anything to the internals.
#17
#18
Vortech Tuner Kit $4000
UTEC and pressure Sensor $900
Walbro Pump $90
DW 600cc Injectors $550
Installation: $1800
Tuning $500
$7840 for a clean basic safe setup. You don't HAVE to get exhaust and gauges. Of course, this is a good starting point, and you are correct, that most people do get cages, and upgraded clutch/exhaust. But not required.
UTEC and pressure Sensor $900
Walbro Pump $90
DW 600cc Injectors $550
Installation: $1800
Tuning $500
$7840 for a clean basic safe setup. You don't HAVE to get exhaust and gauges. Of course, this is a good starting point, and you are correct, that most people do get cages, and upgraded clutch/exhaust. But not required.
#19
Not quite
Trans was fine. It sheared a rear-end gear due to the DSS halfsahfts being slightly too short and not fully engaging the gear. This issue has been resolved though. Still on stock 6spd and stock 3.5 diff.
tom
Trans was fine. It sheared a rear-end gear due to the DSS halfsahfts being slightly too short and not fully engaging the gear. This issue has been resolved though. Still on stock 6spd and stock 3.5 diff.
tom
Sound Performance here in Chicago is pushing over 1000 whp on a stock trans in their 350Z. They ended up shearing the input shaft while trying to launch it with slicks though. http://www.chicagoz.com/forums/showthread.php?t=14974
#21
Vortech Tuner Kit $4000
UTEC and pressure Sensor $900
Walbro Pump $90
DW 600cc Injectors $550
Installation: $1800
Tuning $500
$7840 for a clean basic safe setup. You don't HAVE to get exhaust and gauges. Of course, this is a good starting point, and you are correct, that most people do get cages, and upgraded clutch/exhaust. But not required.
UTEC and pressure Sensor $900
Walbro Pump $90
DW 600cc Injectors $550
Installation: $1800
Tuning $500
$7840 for a clean basic safe setup. You don't HAVE to get exhaust and gauges. Of course, this is a good starting point, and you are correct, that most people do get cages, and upgraded clutch/exhaust. But not required.
Thread
Thread Starter
Forum
Replies
Last Post