i dont know what to do next...i think i have every bolt on possible and i still want more power..im just looking for that extra torque that used to push me back into my seat...and anyone else miss the luxury of an unmodded coupe?...i realized that now my car feels so raw...engine noise..exhaust noise..its lost that quiet luxury feel..well i dont wanna complain and all its still damn fun to drive..but anyone else miss it?

 

by the way i have the UR pulley lying around..will it make a big difference..like will it give me that extra something im looking for?...i was hesitant to install it cause of all the negatives ive heard..(bad idle, idle noise, etc)..and please dont tell me to turbo or super..to much money for me right now..thanks in advance!

 

Well, I got the Fujitsubo y-pipe back with the nismo y-pipe. From captured sound files the exhaust note sounded pretty similar to stock. However, after actually installing it, I was a little disappointed by the loss of that stock growl the G35 had. =\ That's probably the only thing I really miss. From some of the stuff I read about the next gen G35 though, it would seem as though it would be really hard to get any kind of performance gains through bolt-ons. Hopefully the new G35 will have a nice exhaust tone again so if/when I upgrade, I won't touch a thing. =p

 

Can you say, "Turbo-Charge?"

 

Just did the 5/16 motordyne spacer today.. 04 5AT, nice improvement..nothing that will rock your world, but throttle response is noticeably better. Have the Stillen Z tube/air box also in place.
Only 20K miles, so much more fun to look forward to!

 

Jew Claw!!!!

 

I have an K&N cold air intake. and i installed my 5/16" copper iso thermal plenum spacer today.. Talk about a change.. it really climbs at high rpm's and my car will actually pull decent in 6th gear. And the sound is great at the higher rpm's.. really glad i did this mod..

 

hey Diablo, i have a question regarding your UR pulleys...

on your crank pulley(the biggest one) is there a noticable 1MM thick steel sleeve pressed over the other diameter of the hub on the rear of the pulley?

i'm asking cux i just received my pulley in the mail but i don't see the 1MM steel sleeve that its suppose to have, not sure if mines normal or not

 

Look into either a reflash or a piggyback. Technosquare or AAM for the reflash, or utec, greddy emanage ultimate, or unichip for piggybacks.