Registered User
Quote:
+10,000,000Originally Posted by viceversa
so maybe you messed up something when you replaced the brakes? Go back re-check everything.
Registered User
Quote:
Let me know
Thanks!
Leave your battery unplugged for 20 mins. Just disconnect the negative terminal. Then plug it back in after 20 mins. The ECU should loose all the settings.Originally Posted by frank358fr
I replace my spark plug. So I unplug the connector from the throttle body and every other little connector WITHOUT unpluging the battery. Do you think it might be the problem? Do I need to make a reset of the ECU and do you think Ineed to re-do the throttle learning procedures again?Let me know
Thanks!
I just cleaned my Mass Air Flow Sensor and Throttle Body today. I was reading the DIY on cleaning the TB and they said don't unplug the TB connector. But someone said that if you unplug it you can do the re-learn steps for the ECU, or you can leave the battery unplugged for 20 minutes.
I had to unplug it because the TB cleaner said not to get it on plastic or paint. I didn't want to risk it. So before I disconnected the TB, I unplugged the battery. It took be about 30 minutes to clean the TB. I put everything back, and hooked up the battery last. I turned it on and no problems.
Quote:
Can you explain me how to make the re-learn steps?Originally Posted by surma884
But someone said that if you unplug it you can do the re-learn steps for the ECU, or you can leave the battery unplugged for 20 minutes.
Thanks!
Registered User
Quote:
Thanks!
http://lmgtfy.com/?q=350z+g35+ecu+re...eset+procedureOriginally Posted by frank358fr
Can you explain me how to make the re-learn steps?Thanks!
Registered User
I have the same problem! My vdc off light is always on!switch doesn't do anything!I'm wondering if the previous owner did a mod on it??
Registered User
i had the vdc off/slip lights on for a while. changed my brake pads and it was fine. also got my mechanic to clean my throttle body. no lights have come on for the past 2 weeks after the brake change
Registered User
when u disconnect the battery and the vdc/abs/slip light(s) come on you have to recalibrate the steering angle sensor, and sometimes the decel G sensor. Only way to do it properly is w/ consult 2 or 3 at the dealer.
Registered User
My VDC off light came on and its not going away! I shut the car off drove it for 30 miles and everything but even when I restart the car the light is still there what do I do? The button does not do anything.
Registered User
I recently cleaned the throttle body the car starts perfect and my brakes are good i have checked them