I searched the forums and couldn't find a DIY for this, think I found one but it was just a broken link. I have a custom shift boot coming for my '04 5AT as well as a Momo shift ****. Is there a do it yourself for how to install this or could someone give me a hand? I never really mess around with this stuff but I'm learning! Thanks in advance!

 

anyone?

 

I've done it a few times need any help let me know...remove your shift ****, put car in neutral/hit e-brake, and just pull up on the center console area and disconnect the 3 plugs....everything from there on is pretty straight forward

 

Will do thanks. I should be getting them in the mail by next friday.

 

I installed the MOMO shifter. I took out the white plastic piece that was needed for the stock shifter. Makes it sit lower doesn't get in the way of the radio now I had it pushed down to much at first and it seemed to shift fine, but it would not fully engage park. Did not make the car happy.

 

A better way to install the MOMO shift **** is to cut off and reshape the little plastic actuator so it sits lower (Dremel tool is what I used) this way it functions as intended. Installing the boot just requires popping up the plate with a screw driver carefully and disconnecting the wires. You may need to cut away some of the mesh under the boot so it works correctly....I did!
Gary

 

Hey guys so I'm having some trouble. Check out the video and tell me what I'm doing wrong?

http://www.youtube.com/watch?v=cGAOU...ature=youtu.be

 

So what was the fix? Another video clip?