G35 Coupe V35 2003 - 07 Discussion about the 1st Generation V35 G35 Coupe

Only control to move back and fourth works on driver seat

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old May 13, 2018 | 07:12 PM
  #1  
FahBreezy's Avatar
Thread Starter
|
Registered User
Joined: May 2018
Posts: 25
Likes: 0
Question Only control to move back and fourth works on driver seat

Hey guys, first post here. Yesterday I picked myself up a 2006 g35 coupe and one thing I didn't notice before purchasing the vehicle was that the only electronic control that works on the driver side seat is the control to move back and fourth. I am not to worried about fixing the problem now, unless its going to cost less than $100, but I need to lower the position of the seat very badly. It breaks my kneck trying to drive that thing at the current seat height. Any help would be great.
 
Reply
Old May 13, 2018 | 10:14 PM
  #2  
cleric670's Avatar
BANNED!!!
Joined: May 2017
Posts: 14,837
Likes: 2,495
From: Washington State
Coupe 6MT Premium RAS
Premier Member

Unbolt the seat and rock it backwards to access everything, be careful to not damage or strain the wiring especially the YELLOW harnesses which are for the SRS system. I recommend stacking something under the bracket because the seat weighs a ton, then you can unplug the harnesses and verify there is power going to them, if you have power when you operate the switch then the motors have failed, if you don't have power it could be the switch or possibly the circuit (which I doubt since you have SOME function).

You can manually adjust the seat positions usually by unbolting the motor and manually turning the gearbox with a wrench/socket/etc depending on what the mating driveshaft uses.
 
Reply
Old May 14, 2018 | 01:27 AM
  #3  
FahBreezy's Avatar
Thread Starter
|
Registered User
Joined: May 2018
Posts: 25
Likes: 0
Originally Posted by cleric670@gmail
Unbolt the seat and rock it backwards to access everything, be careful to not damage or strain the wiring especially the YELLOW harnesses which are for the SRS system. I recommend stacking something under the bracket because the seat weighs a ton, then you can unplug the harnesses and verify there is power going to them, if you have power when you operate the switch then the motors have failed, if you don't have power it could be the switch or possibly the circuit (which I doubt since you have SOME function).

You can manually adjust the seat positions usually by unbolting the motor and manually turning the gearbox with a wrench/socket/etc depending on what the mating driveshaft uses.
Thanks man, I'm dropping it off at a mechanic tmwr for a royal flush and an alignment so I'll give it a go after that.
 
Reply
Old May 14, 2018 | 07:28 AM
  #4  
Blue Dream's Avatar
I drove ttrank's car solo
iTrader: (50)
Joined: Mar 2009
Posts: 18,299
Likes: 1,488
From: By the sea, Tx
G35 sedan w/ too much money in mods
Premier Member

I was going to suggest to take a can of electrical contact cleaner and liberally spray the switch from above and let dry. That worked on our G for a while then the seat wouldn't move backward and the seat back wouldn't move forward. We currently have the seat out of the car to be disassembled for a thorough cleaning. Hopefully this will work, I don't believe we can buy a new one.
 

Last edited by Blue Dream; May 14, 2018 at 07:44 AM.
Reply
Old May 14, 2018 | 10:26 AM
  #5  
jbarnett250's Avatar
Registered User
10 Year Member
Liked
Loved
Community Favorite
iTrader: (1)
Joined: Sep 2014
Posts: 377
Likes: 55
From: Walpole MA
my money is on the seat switch. this symptom is so common on the forums. my passenger seat switch failed too. i took it apart and it looked just like all the pictures you can find on the internet and youtube. the contacts get pitted and covered with carbon and stop working. you can remove the switch and take it apart and clean the contacts but it's a little tricky. i lost the return spring during reassembly and had to use a spring from a pen to get it to half work. i saw a switch assembly on ebay a while back for $40 but any used one may be like the one you have. good luck.
 
Reply
Old May 14, 2018 | 12:31 PM
  #6  
FreshLikeAG's Avatar
Registered User
Joined: Jun 2013
Posts: 829
Likes: 99
From: Tampa, Fl
Same thing happen to my passenger seat switch. Lost the recline function. The contacts needed to be cleaned and got a couple years out of it but its back to haunt me again. It's odd though that you lost both functions. Usually one will work and the other not. Example, my seat will recline but no go back up. So if you lost both functions I'd suspect a motor
 
Reply
Old May 14, 2018 | 06:40 PM
  #7  
Scorpi0's Avatar
Registered User
Joined: Feb 2018
Posts: 3,087
Likes: 445
From: LA, Cali
Get yourself a 1/4 bit ratchet like this and u wont have to unbolt the seat to fix the switches.
 
Reply

Trending Topics

Old May 15, 2018 | 06:35 AM
  #8  
Blue Dream's Avatar
I drove ttrank's car solo
iTrader: (50)
Joined: Mar 2009
Posts: 18,299
Likes: 1,488
From: By the sea, Tx
G35 sedan w/ too much money in mods
Premier Member

Huh?
 
Reply
Old May 15, 2018 | 08:25 AM
  #9  
cleric670's Avatar
BANNED!!!
Joined: May 2017
Posts: 14,837
Likes: 2,495
From: Washington State
Coupe 6MT Premium RAS
Premier Member

Guessing it's for those screws on the console side which are down in the "crevice of no return".
 
Reply
Old May 15, 2018 | 10:09 AM
  #10  
FreshLikeAG's Avatar
Registered User
Joined: Jun 2013
Posts: 829
Likes: 99
From: Tampa, Fl
Still, I couldn't imagine repairing that switch in the vehicle. You're going to lose something and end up removing the seat to find it anyway
 
Reply
Old May 16, 2018 | 03:22 AM
  #11  
Scorpi0's Avatar
Registered User
Joined: Feb 2018
Posts: 3,087
Likes: 445
From: LA, Cali
Originally Posted by cleric670@gmail
Guessing it's for those screws on the console side which are down in the "crevice of no return".
Yup thats what I mean....and how I fixed my seat controls.
 
Reply
Old May 16, 2018 | 03:25 AM
  #12  
Scorpi0's Avatar
Registered User
Joined: Feb 2018
Posts: 3,087
Likes: 445
From: LA, Cali
Originally Posted by FreshLikeAG
Still, I couldn't imagine repairing that switch in the vehicle. You're going to lose something and end up removing the seat to find it anyway
Haha...I actually did end up dropping some parts in there. And the parts werent magnetic, so I used some bubble gum on the end of a screwdriver to pick them back up lol.

So I would suggest covering up the gap in between the seat and center console with masking tape so anything that falls wont end up in the depths of hell.
 

Last edited by Scorpi0; May 16, 2018 at 04:00 AM.
Reply
Old May 16, 2018 | 08:05 AM
  #13  
LoSt180's Avatar
Premier Member
iTrader: (11)
Joined: Mar 2011
Posts: 2,796
Likes: 468
From: Maryland
Premier Member

Driver's side seat switch is replaceable. I think it's about $100-150 new. Infiniti won't sell the passenger seat switch separately so I had to find a used one.
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
MJION
G35 Sedan V35 2003-06
1
Sep 18, 2017 07:54 AM
poloavirex
G35 Coupe V35 2003 - 07
8
Jul 18, 2017 07:41 PM
clinthammer
G35 Sedan V35 2003-06
9
Apr 15, 2012 10:36 PM
g35florida
Accessories
4
Sep 8, 2010 12:21 AM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -4. The time now is 11:59 PM.