Need help
#1
Need help
My throttle body went bad and ordered a new one and installed it today and went and took a ride to feel how the new throttle Body was it was fine but after I Parked and turn off the car took a look at my tire a seen smoke only if you get close you’ll see it not from far away opened the hood and threw water on it and after that I start up and started up fine but took a look at the bottom and seen this 😞😭
Last edited by manuels04; 06-14-2024 at 09:23 PM.
#2
#4
My throttle body went bad and ordered a new one and installed it today and went and took a ride to feel how the new throttle Body was it was fine but after I Parked and turn off the car took a look at my tire a seen smoke only if you get close you’ll see it not from far away opened the hood and threw water on it and after that I start up and started up fine but took a look at the bottom and seen this 😞😭
Also, the FSM recommends you perform the throttle body closed position procedure after disconnecting the throttle body. The idle air volume learning procedure after replacing the throttle body
There are YouTube videos that walk you through it, but I'll leave some pages from the FSM to perform the procedure.
This is from the FSM page EC-79, EC-80
#6
Thread
Thread Starter
Forum
Replies
Last Post