Sup guys,
I just tried to install my NISMO Cold Air Intake for my 05 coupe. Everything was going well until the MAF Sensor part. The directions are for a 2004 350Z so the pictures looked a little different. Anyways, I gave up cuz i was losing light fast so i just put the stock intake back on...which was also a bitch cuz its 96 degrees outside.. Anyways, I'm frustrated and i think imma just wait for the headers to come and then send it into to a shop to get it installed. sux... Anyone install their NISMO intake have any suggestions?

foobs

 

what was so hard bout it??? you just remove the MAF from the stock air box and attach it to the new intake.

 

i just realized that i had the bolts backwards and that's why it wasn't connecting... ill try again tomorrow....

 

wow!!!!

 

yeah you are a retard




ahah jk

 

ok guys,
so i got too anxious again and just installed it! Not completely though, where it goes all the way down. I think i may need some help with that. Short Ram'd for now i guess. But tell me if this is ok, its basically just the upper pipe to the MAF, the conector directly to the filter. I have quite a few extra pieces and it sounds ok. It won't kill my car will it? haha

 

how do i reset the ecu?

 

nvm about the ECU, i found the post. But does my installation sound ok for the car?

 

so you hooked up the filter directly to the MAF??? can you take some pics to get a better idea of what ur talkin bout

 

As long as you have filtered air going into the tube your just fine.

 

i tried escobar but my damn digicam is decided to stop working! argh. anyways, its basically the MAF > Metal Connector > rubber connecter > the filter.

 

basically the extra parts i have are the bypass valve and the tube that has the support thingy on it.

 

If your car blows up, then you installed it wrong.

 

Is the digicam hooked up to the MAF? lolololol...

 

try this, pull out the syringes in your arm and give it another go.