New Alignment: Toe-in looks off
New Alignment: Toe-in looks off
I've just had my car aligned, and from what i can tell its way better then before. However a couple of the specs, most importantly the front TOE is worrying me. It says on the spec sheet Total Toe-in = 0.08-0.0 and mine is .10
Should I be worried? Premature tire wear possible?
Here are the specs
Before/After
REAR
L Camber R Camber
-1.7/-1.3 -1.9/-1.3
L Toe R Toe
0.16/0.05 0.20/0.05
Total Toe
0.37/0.10
FRONT
L Camber R Camber
-0.8/-0.8 -1.2/-0.10
L Caster R Caster
8.3/8.3 8.3/8.2
L Toe R Toe
0.10/0.05 -0.03/0.05
Total Toe
0.10
Should I be worried? Premature tire wear possible?
Here are the specs
Before/After
REAR
L Camber R Camber
-1.7/-1.3 -1.9/-1.3
L Toe R Toe
0.16/0.05 0.20/0.05
Total Toe
0.37/0.10
FRONT
L Camber R Camber
-0.8/-0.8 -1.2/-0.10
L Caster R Caster
8.3/8.3 8.3/8.2
L Toe R Toe
0.10/0.05 -0.03/0.05
Total Toe
0.10
Last edited by BocaCoupe; Aug 31, 2005 at 09:05 PM.
Hooman, there is a TSB on drifting to the right. Did you ever get the rod end replaced?
Alignment is under warranty for 1 year. I am just over the 1 year mark and my tires have been cupping/feathering but I didn't bring it up until now, and they are giving me a hard time about covering it.
Alignment is under warranty for 1 year. I am just over the 1 year mark and my tires have been cupping/feathering but I didn't bring it up until now, and they are giving me a hard time about covering it.
Thread
Thread Starter
Forum
Replies
Last Post
vrsc
G35 Sedan V35 2003-06
14
May 26, 2006 07:42 AM
kenchan
Engine, Drivetrain & Forced-Induction
4
Oct 29, 2004 03:56 PM




