What speed not to exceed during break-in.
#3
#4
Re: What speed not to exceed during break-in.
says 60, but thats not always safe.. I wouldnt do over 75. I dont think the wheel bearings need *that* long of a breakin. But I wouldnt heat them up much right off the lot. Same with the tranny.. Try not to build up too much heat.
I've heard of failing wheelbearings on 5th gen maximas, so its not unheard of.
----------------------------------------------------
bs g35c lth/prem - a poser with no lsd
I've heard of failing wheelbearings on 5th gen maximas, so its not unheard of.
----------------------------------------------------
bs g35c lth/prem - a poser with no lsd
#5
#6
Re: What speed not to exceed during break-in.
not true.. Toyota & Honda yes, Nissan no...
BTW, you make the most HP at 5K. Another difference is that the VQ is a 200K+ motor, the others are generally not.
----------------------------------------------------
bs g35c lth/prem - a poser with no lsd
BTW, you make the most HP at 5K. Another difference is that the VQ is a 200K+ motor, the others are generally not.
----------------------------------------------------
bs g35c lth/prem - a poser with no lsd
#7
Trending Topics
#9
Re: What speed not to exceed during break-in.
a tech at a dealership from Infiniti manufacturing said they do not break in the engine before or after they install it in the car. They just make sure it works, put it together and ship it out.
"Moderation in all things, including moderation."
"Moderation in all things, including moderation."
#11
Re: What speed not to exceed during break-in.
My cents. I agree that it is my belief that you should not exceed 100 MPH during break in, prolonged RPM rate i.e. Long Fwy usage, is probably not good on motors that support Variable timing, or so that I have heard. Can someone educate me on the VQ, is it variable timing controlled?
"Use the Forced Induction Luke!"
-Jedi
2003 G35C, 6MT, Navi, Black Obsidian/Graphite
"Use the Forced Induction Luke!"
-Jedi
2003 G35C, 6MT, Navi, Black Obsidian/Graphite
Thread
Thread Starter
Forum
Replies
Last Post
joel extreme
SOCAL Meetings & Events
0
09-29-2015 04:44 AM