Ses
#1
Ses
So I changed my oil put on some stillen sways and checked the bolts on my 5/16 spacer. So all was going well untill my brother got the torque wrench out and didnt feel the click or something and broke the middle top plenum bolt off. So we had to take it apart and get the bolt out. We got it out fine with some vice grips. So we had to go find another bolt and before we left I had to close my sunroof. Well I turned on the igniton to do this and the to plugs on the back of the plenum were unplugged. I think its the drive by wire and something else. Would this still cause a SES light even though everything is hooked up now. Also where can I get a bolt to replace the one that broke I got a new one that I put in the back right where the Z tube hooks up. Its not an automotive grade bolt so I need to replace it but I figured it would be ok for now. I looked on motordyne website and the only thing they sell is the whole bolt kit for $45 and Im not doing that for 1 bolt. Thanks
B
B
#2
#3
Originally Posted by 03Sg35
You can get the bolt at your local NAPA or any hardware store, trueValue or something. SES light can be reset by the dealer or by unplugging the battery for 30min gl
I went to Lowes and they had it but its not automotive grade. Napa was closed so Im gonna try them again today. Its a metric bolt so it may not bethat easy to find.
Thread
Thread Starter
Forum
Replies
Last Post
Wayne9011
Engine, Drivetrain & Forced-Induction
2
07-27-2015 11:25 AM