brake lights don't work...help...
#1
brake lights don't work...help...
I failed inspection for one thing. None of the rear brake lights (including spoiler light) light up when I press the brake pedal. They gave me 48 hours to get it fixed because of the seriousness of the problem!
I don't think it's the bulbs themselves because like I said, none of them work. That would be a big coincidence for all 3 to burn out together. I recently had my pads replaced. Is there a sensor that the mechanic perhaps missed?!?
thanks in advance!
I don't think it's the bulbs themselves because like I said, none of them work. That would be a big coincidence for all 3 to burn out together. I recently had my pads replaced. Is there a sensor that the mechanic perhaps missed?!?
thanks in advance!
#2
Registered User
iTrader: (11)
most likely it's the brake light switch, he messed with while doing the brake job. Could be an easy fix,
See page BR-6 for location of the switch: http://www.g35frenzy.com/downloads/2...anual/F/br.pdf
PS: CHECK THE FUSE!!!!
See page BR-6 for location of the switch: http://www.g35frenzy.com/downloads/2...anual/F/br.pdf
PS: CHECK THE FUSE!!!!
#4
Registered User
iTrader: (14)
Join Date: Jul 2005
Location: Goodyear, AZ
Posts: 773
Likes: 0
Received 0 Likes
on
0 Posts
+1 check your fuses
Also, check under the hood and see if any plugs are disconnected. If he followed the correct procedures for bleeding the brakes, you're suppose to disconnect the VDC actuator. He may have disconnected the wrong plug, or more plugs and forgot to reconnect them. If all of that is good, I'd bet it's the brake switch behind the pedal.
Also, check under the hood and see if any plugs are disconnected. If he followed the correct procedures for bleeding the brakes, you're suppose to disconnect the VDC actuator. He may have disconnected the wrong plug, or more plugs and forgot to reconnect them. If all of that is good, I'd bet it's the brake switch behind the pedal.
#5
#7
Trending Topics
#8
Well today I replaced the stop light switch and scanned the car for engine and brake codes. 1805 came up and "pressure sensor circuit" !@##$???
After reseting the ecu to take the abs, slip, and traction lights off the dash, the brake lights starting working again.
went for reinspection and passed. done.
thanks again!
After reseting the ecu to take the abs, slip, and traction lights off the dash, the brake lights starting working again.
went for reinspection and passed. done.
thanks again!
Thread
Thread Starter
Forum
Replies
Last Post