Stance LX vs. Tein CS
Joined: Mar 2007
Posts: 392
Likes: 3
From: Anaheim, CA Socal
Stance LX vs. Tein CS
I am looking for some coilovers for my daily driven G35. I have read that these are both for "luxury" type vehicles. I am looking to lower my car 2-2.5 inches and I am looking for comfortable ride quality. Which one should I go with and why?
Thank you.
Thank you.
I've ran the Tein CS and just installed the Stance LX yesterday on my car.
The Tein, are a nice smooth OEM like ride that is a little stiffer than OEM on it's highest setting. For me, it winded up being too soft of a ride and I wanted something more stiffer for a sportier feeling.
The one thing I didn't like about the Tein was that you lose the pre-load of the spring when you start lowering the car considerably. Over larger bumps, you actually get a slight rattle out of the spring boucing around upfront because of the suspension travel. (make sense?) I don't quite remember at what height you lose the pre-load though but I was dropped at least 3 inches. On the Stance, the pre-load collars and the lowering collar are seperate from each other so you will never lose the pre-load. I installed a set of LX's on a sedan a few weeks back over here but I don't remember his screen name. I'll see if I can dig it up or hopefully he (Adler) see's this thread.
Oh...both shocks are made of mono-block construction which is a good thing. Stance are a good few hundred dollars less than Tein last time I looked as well.
The Tein, are a nice smooth OEM like ride that is a little stiffer than OEM on it's highest setting. For me, it winded up being too soft of a ride and I wanted something more stiffer for a sportier feeling.
The one thing I didn't like about the Tein was that you lose the pre-load of the spring when you start lowering the car considerably. Over larger bumps, you actually get a slight rattle out of the spring boucing around upfront because of the suspension travel. (make sense?) I don't quite remember at what height you lose the pre-load though but I was dropped at least 3 inches. On the Stance, the pre-load collars and the lowering collar are seperate from each other so you will never lose the pre-load. I installed a set of LX's on a sedan a few weeks back over here but I don't remember his screen name. I'll see if I can dig it up or hopefully he (Adler) see's this thread.
Oh...both shocks are made of mono-block construction which is a good thing. Stance are a good few hundred dollars less than Tein last time I looked as well.
Thread
Thread Starter
Forum
Replies
Last Post
THMotorsports
Suspension-Vendor
257
Dec 18, 2018 05:43 PM



but that is on the Tein CS only. You wouldn't have that issue with the Stance.

