Now I've gone through all the threads about swapping the coupe seats into the sedan and the drivers side is pretty simple for the most part but my 03 sedan didn't come with a power passenger seat. It was just the regular run of the mill bar that you pull up and the seat slides back and fourth. When I install the passenger coupe seat (which is obviously power) am I going to run into any issues with this? Any info would help, I plan on doing this today so i guess for the mean time I will start on the drivers side. Thanks guys

https://g35driver.com/forums/g35-sed...ring-info.html should get a start on some info on how to do them, if not I would PM him.

/\ thanks that helped out alot the seat is installed and works fine only thing is the air bag light in flashing on and off now

It's been a while since I put mine in and I can't quite remember but I think there is a airbag plug up behind toward the outside of the seat if you follow the harness wires. Are you sure everything was plugged in? The harness/plugs that are yellow are for the airbags.

Yea i saw the yellow plug and they were connected fine. I followed the wire as far back i could and i didn't see anything else attached. I will get back under there in a day or so when i install the pass side. Thanks though

Did you turn the power on during the installation by any chance? If you turned it on while the air bag is disconnected, the light will flash even after you connect it back. Do the reset first, if it doesn't fix it then the air bag might be faulty.

No problem. Good luck

How do you do the reset?

Just do a search using keyword "airbag reset" and the DIY thread should be within the top 5 results.