having gas gauge problems
having gas gauge problems
I have a 2005 infiniti g35x sedan. my gas gauge has been reading full since I bought it with the check engine light on, I replaced the driver side float hoping it would be the easier one but I was wrong. my emissions is due so I replaced the passenger side float, fuel pump and strainer. still no luck still reading the tank is full with same code, where the heck do I go from here
Follow the troubleshooting steps in the FSM
Telcoman
Telcoman
https://www.nicoclub.com/FSM/G35/Sedan/2005_G35_Sedan/
Section DI somewhere around page 18 shows the steps for testing resistance to verify the float is sending the correct signal, also do the DIAGNOSTIC MODE to make sure the needles physically move.
If the sender is outputting the correct resistance values then your combination meter is probably fried, this is VERY common btw.
Section DI somewhere around page 18 shows the steps for testing resistance to verify the float is sending the correct signal, also do the DIAGNOSTIC MODE to make sure the needles physically move.
If the sender is outputting the correct resistance values then your combination meter is probably fried, this is VERY common btw.
Thread
Thread Starter
Forum
Replies
Last Post








