^^^ Pics?

 

credit card clears it... llolz

 

I have an 07x

 

I have eibach springs for sale. I had them on my car for about 15,000 miles only $ 85. Pm me if your interested and well see what we can do for shipping

 

sedan fender clearances are about the same for the rears...
I know cause my old rims are on a 2011 g37xs sedan... same fitment...

 

So lowering the car on Eibachs will defentily suck the wheel into the fender with just putting in the springs? The wheel sticks out a good amount right now...

 

it would make it flush with a 245/35 tire

 

Eibachs... I dont know. theyre weak drop... I know for a fact coupe H&Rs on the sedan will do the job, but you will be low as me on springs... lol not my favorite ride.

 

I am currently on 18x10 +25s all around, 255/35 and 265/35 in the back. looks great but its no 20.

 

I don't mean to thread jack but do you rub at all? Im thinking of doing the same setup, except with +22 offset...would that still work?

 

I don't know how you do it. I am on 9.5 +34 rear and -1.7 camber with 275s and rub on large dips in the road. Your setup is +22mm more than what I'm running now! Props man.

Edit: Perhaps it's the extra inch of width that gives you a slight stretch?

 

Extra inch only makes it worse lol
maybe your problem is too wide on 9.5 tire so sidewalls become bubble. if you look at my pix, 275 nankang side walls curve in, due to Nankangs running a little small.

I maxed out bc coils in the rear on 200mm springs, and raised maybe a finger gap higher on 20s now, but it sits at u see in the pix.
I know im running a lot more camber then 1.7 tho. Its all natural camber from slammage. my camber kit is sitting in my trunk for the past year lol

 

snapped a pic at a gas station...
20x10.5 +25 (20mmspacer) 275/30/20

 

I wouldn't even consider running this setup on Eibach springs. You need coilovers and you need a nice drop (no fender/tire gap, but preferably tucking tire).