Thanks guys for the kind words, means a lot!
Thanks! It's very snug against the mesh, The thick rubber pressed against the mesh seems to do a good job keeping it in place. No pics from me for the fogs out of the bumper, here's the site I got them from w/ good closeups of the EXACT lights I purchased. You can zoom in w/ your pointer over the photos~
http://tlnautoparts.com/index.php/08...ed-na02-c.html

 

^i was more interested in seeing a close up of the fogs on the bumper from the front view. looks questionable how the fogs finisher flares out a bit much. i think projector fogs woulda been nicer than the leds. looks a bit cheesy. but still nice job

 

Here you go~

 

u should use a different finisher thats more flush imo. itll look more in place.

 

Probably something you'd have to see in person, IMO they blend w/ the mesh and the bumper angle pretty well.

 

The fogs look great and your car looks really sharp. Great job!

 

Should have put them to the far corners. Would have made the car look wider.

 

Thanks for the compliments, appreciate it!
Like I mentioned previously, the way the bumper angles more sharply at the ends and the washer fluid tank clearance made that a no go.

 

DIY thread is now up, if you have any further questions shoot me a PM or you can post them here
https://g35driver.com/forums/v36-diy...ts-bumper.html

 

It looks great. It seems very difficult to do... Probably not something I'll do on my own.

 

Thanks for the kind words
The project is really quite simple if you're not shy about cutting holes in your car
But I can see that for some folks cutting into your car is not their cup of tea

 

^u should do something with a oem switch of some sort to utilize the empty slot on the console. i have my fog light switch in the same place same switch too but i snaked the wire in the hole behind the hood release latch

 

That may be something I'll check out down the road, would be nice to have factory switchgear so it all ties together. Luckily the switch is pretty much out of view so it doesn't really draw attention. But definitely a good suggestion, thanks! Do you have any pics of the switch you're referring to and a part # by chance??

 

something like this should fit

http://www.ebay.com/itm/nissan-nx200...9a9265&vxp=mtr