General Tech Questions This Forum is Only for Questions and Posts that Do Not fit under the other Tech categories.(No Classified Posts)

No crank, no start. Please help!!!

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old Dec 26, 2012 | 10:47 AM
  #16  
bdubct's Avatar
Thread Starter
|
Registered User
Joined: Dec 2012
Posts: 44
Likes: 0
From: 860 - CT
just found a good fix instead of buying a new clutch pedal, use this!

https://g35driver.com/forums/engine-...al-remedy.html
 
Reply
Old Aug 9, 2020 | 09:06 PM
  #17  
Noah Blackstock's Avatar
Registered User
Joined: Aug 2020
Posts: 1
Likes: 0
Infiniti G35 Sports Package
Originally Posted by bdubct
2003 g35 coupe 6 m/t 76k miles

Yesterday i went to start my car and i go to start it, nothing. No crank and it wont start. So I checked all the fuses (near clutch + under hood), all good. I tried pop starting it and it started right up and I drove home. (tested the battery 12.59 volts and the alternator at 14.8 and with a load [headlights, heat, radio] it went down to 14.4). So i ruled out it couldnt be a bad battery nor a bad alternator. no corrosion around the battery terminals. I decided to buy a new starter today, put it in and went to start the car– nothing. No crank no start still. so i pop started it again, runs like a champ. serpentine belt is good all the pulleys run strong. Not the anti-theft car alarm because it recognizes the key. So Im pretty much clueless from here.... anyone have any ideas? In the box with the new starter was a bulletin staying if you have no crank no start and have these symptoms, then you need a new IPDM (Intelligent Power Distribution Module) and for my year the part number was 284B7-AL51B.

BOTTOM LINE
-No crank no start
-not the starter, alternator, battery, fuses, car alarm
-could be the starter relay located in the IPDM, but how do i check a relay? if it was bad wouldnt it be clicking when i try to start it and the engine 'attempts' to roll over?

what else could it be?! is it the IPDM? any advice would be greatly appreciated

-thanks!


here is the bulletin i was referring to.

It definitely could be the ECU wiring harness. I would pull the kickdoor covering the ECU and see if any of the wires are loose.
 
Reply
Old Aug 10, 2020 | 05:45 PM
  #18  
05_SkylineSedan's Avatar
Registered User
20 Year Member
Joined: Apr 2005
Posts: 649
Likes: 112
Not only is this an 8 year old thread but a few posts ago he solved it. In his case it was the clutch pedal switch.

Welcome to the forum though.
 
Reply
Old Apr 19, 2025 | 02:12 PM
  #19  
slowvq95's Avatar
Registered User
Joined: Apr 2025
Posts: 1
Likes: 0
Originally Posted by bythabay
inspect and just the clutch pedal fully pressed switch. If all is ok there, disconnect the switch and put a wire across the two terminals of the wiring harness - this will effectively bypass the switch and allow you to start the car as if the pedal is pressed down. Make sure you are in neutral.
hi. I noticed I might have the same issue . Idk if I’m late and can get help . But I tried everything on mine and I tested the starter fuse and the fuse port for it and I get no power at all on it . So I seen the ipdm is next for the starter relay but how can I confirm before I pull the trigger for that part .
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
brianuc4
Engine, Drivetrain & Forced-Induction
19
Apr 10, 2020 02:12 PM
magnetism80
G35 Coupe V35 2003 - 07
5
Feb 1, 2019 10:00 AM
andrewvk
Engine - Complete Motors
32
Apr 7, 2016 01:39 PM
sullivan72
G35 Coupe V35 2003 - 07
4
Sep 22, 2015 11:39 PM
Rhinos7777
Engine, Drivetrain & Forced-Induction
3
Sep 6, 2015 05:36 PM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -4. The time now is 03:37 AM.