Did you guys tighten as you went or waited until the end of the install? When I did mine I hung everything, put the bols/nuts on by hand as I went then at the end I went back and made sure everything was tight.

 

I've got the raddle too. It's really annoying. Randy, didn't u have a hanger welded on? Any pics?

04' G coupe/TB/Prem/Sport/Nav/35% Tint/Injen CAI/Injen Exhaust/Clear corners/V5 Plenum/GroundingGear/Nismo caps/Custom TS ECU/Hotchkis Sways
Plates: 1REVER1

 

Injen has my car right now so they can resolve this issue...PM our good friend Duy over at Injen Tech and he'll get you squared away...his handle on this forum is "INJEN"

2 G or NOT 2 G, there is no question!

Injen SES, Kinetix cats, K&N Typhoon, 19" PIAA Super Rozza's (19x9 & 19x10)

 

Rueb,

As you can read above, Injen has my car right now and is willing to fix any problems ppl have. PM "INJEN" (Duy at Injen Tech) and he'll take care of you. No pics of the hanger though. It's welded the the center res. right above the cross member.

2 G or NOT 2 G, there is no question!

Injen SES, Kinetix cats, K&N Typhoon, 19" PIAA Super Rozza's (19x9 & 19x10)

 

Randy,
Thanks for the info.
I actually took my G into my buddies shop. So far the easy fix has been just change out the rubber bushing on the hanger. Its working OK so far.

04' G coupe/TB/Prem/Sport/Nav/35% Tint/Injen CAI/Injen Exhaust/Clear corners/V5 Plenum/GroundingGear/Nismo caps/Custom TS ECU/Hotchkis Sways
Plates: 1REVER1