Nismo vs Fuji vs Stillen Gen.2
#31
because this sounds really nice: http://www.youtube.com/watch?v=I9BJ1sRiBJY
#32
^ i'm a newb when it comes to this, but what's better: metallic cats or ceramic cats? I'd rather have cats than resonators in that section, so motordyne's art pipes are out for me. I'm looking for the quietest HFCs possible.
@Alan - the reason i'm trying to sort out all the quietest components is because I KNOW its going to get very loud of it dont. When i'm all done I want to get an Osiris tune and see if i can beat the G37
my exhaust plan so far
[ aftermarket headers ] = [ 400 cell cats ] = [ 350z hr ypipe ] = [ fujitsubo cat back ]
i'm assuming that the fujitsubo includes a mid-pipe section, and its not just a muffler, correct?
@Alan - the reason i'm trying to sort out all the quietest components is because I KNOW its going to get very loud of it dont. When i'm all done I want to get an Osiris tune and see if i can beat the G37
my exhaust plan so far
[ aftermarket headers ] = [ 400 cell cats ] = [ 350z hr ypipe ] = [ fujitsubo cat back ]
i'm assuming that the fujitsubo includes a mid-pipe section, and its not just a muffler, correct?
Last edited by split; 03-11-2010 at 02:32 PM. Reason: added cheesy exhaust diagram
#34
#36
so my new proposed plan for the exhaust side is:
Stock Header
FI 400 cell HFCs
350z HR Y-Pipe
Fujitsubo Exhaust (mid-pipe and muffler section)
the only thing that concerns me is that the inlet pipe on the HR Y-Pipe is probably 2.0" and the outlet on the FI 400 cell HFCs is probably 2.5". If the FI 400 cell HFCs are 2.0" then that's probably going to be the perfect setup!
Stock Header
FI 400 cell HFCs
350z HR Y-Pipe
Fujitsubo Exhaust (mid-pipe and muffler section)
the only thing that concerns me is that the inlet pipe on the HR Y-Pipe is probably 2.0" and the outlet on the FI 400 cell HFCs is probably 2.5". If the FI 400 cell HFCs are 2.0" then that's probably going to be the perfect setup!
#37
#40
Thread
Thread Starter
Forum
Replies
Last Post