Intakes and AF Mixture
Intakes and AF Mixture
Hey guys & girls,
I just bought an 06 G35 coupe with a rev up motor. I have done a lot of research and I am ordering a Motordyne MREV2 lower plenum, either a Stillen short ram(w/box) or induction, and I already have my Motordyne 5/16" spacer. Has anyone tested to see if this makes the VQ run lean or will my OEM MAF sensor correct the mixture with those mods?
I just bought an 06 G35 coupe with a rev up motor. I have done a lot of research and I am ordering a Motordyne MREV2 lower plenum, either a Stillen short ram(w/box) or induction, and I already have my Motordyne 5/16" spacer. Has anyone tested to see if this makes the VQ run lean or will my OEM MAF sensor correct the mixture with those mods?
Joined: Mar 2009
Posts: 18,299
Likes: 1,488
From: By the sea, Tx
G35 sedan w/ too much money in mods

You'll be running a little lean if you're still on the stock exhaust and the ECU won't be able to compensate. If you add an exhaust and/or HFC/test pipes you'll be running dangerously lean and would need a custom tune like Osiris to fix your AFR.
Joined: Mar 2009
Posts: 18,299
Likes: 1,488
From: By the sea, Tx
G35 sedan w/ too much money in mods

Yep you definitely need a tune. Just remember that at high RPMs you run the risk of knock and detonation that can seriously damage your engine.
I really just want it to be reliable and not have problems. I want to do it the right way and keep the car from having problems especially at higher RPMs.
Last edited by JUST1NSANE; Feb 11, 2012 at 09:44 AM.
That setup will run a bit lean but unless you throw exhaust and replace the cats with hfc or especially test pipes, your car will be just fine without a tune. One other thing, when or if you decide to get a tune, its best to get it Dyno tuned at an uprev licensed shop, should be cheaper then 699 and your gains will be maximized.
Trending Topics
So looking at this thread its safe to say with the following mods i would be running quite lean without a tune on my 05 coupe
Alphawerks headers
FI exhaust
FI test pipes
Mrev2
Spacer
ztube
If i keep it in the lower rpm range i should be fine though?
Alphawerks headers
FI exhaust
FI test pipes
Mrev2
Spacer
ztube
If i keep it in the lower rpm range i should be fine though?
You will be running like dick and won't be getting half the performance you should be. You need a tune.
Just check up on this thread
https://g35driver.com/forums/tuner-d...heets-ftw.html
Just check up on this thread
https://g35driver.com/forums/tuner-d...heets-ftw.html
Thread
Thread Starter
Forum
Replies
Last Post








