Ok so many of you told me so....but I bought them anyway....BIG mistake..yes I should have listened ... This is the first & last time I buy anything made by MR... I had a fitment issue with the drivers side header hitting the steering, i had to heat the tube & bend it to make it clear. 3 weeks after install the drivers side bracket weld broke off the tube, leaving 2 holes in the tube. just last weekend the rear o2 sensor bung weld broke completely out of the collector tube & fell out, when the o2 sensor came & got ripped out of the harness ruining the o2 sensor & before it got torn off, it hit the bottom of the transmission pan, denting it & caused the wiring harness inside it to get pinched between the valve body causing the wires to be shorting out & not allowing the car to start. This is all bc Megan Racing quality is cheap, using 18 gauge piping which is way to thin.

 

That sounds like a PITA

 

Ouch!! That blows

 

that sucks

 

Man, that's awful! Sorry for your nightmare, costly mistake....we all live and learn!
Gary

 

Finally had a chance this am to go to the shop & work on the car...got it all fixed, including new welds to the holes in the left tube where the bracket came off & new o2 bung welded in the collector...I see why the welds broke, this piping is paper thin...

 

well that was fast, nice work!

 

I was looking at a set of MR shorty headers, but heard they rubbed the steering shaft and didn't seem like good quality. Sorry to hear this!

 

Its threads like this that make me feel good about dropping a grand on headers.

 

Crap. & I just bought a Megan racing y pipe