So i took out the A/C,compass,airbag console in the dash and went to replace the LEDs in it and i started with the compass section then went to test it out and they werent working. So i then replaced the airbag light and it worked just fine. I've replaced other LEDs in my car on the door switches and what not and never had a problem. is it possible to blow that section of the board with to much heat?

 

Heat? The voltage may need to be geared down or the amps may be wrong

 

all that is fine. ive done all the door switched and they all worked.

 

the only other thing i can think of is that all the LEDs are bad from the get go but i highly doubt that cinsidering i tried about 6 of them. could the C notch on the LED be backwards?