there are two screws in the top of the wheel well, the clips are all around, just keep removing all the clips you see to pull off the liner, if i could see the pic, then i would circle it for u

 

 

i installed them myself...its very very easy to install..first i thought it would be alot of thingy needed to do..but took me 30mins for the first side and 15min for the 2nd...most the time is spended on taking off the heavy wheels..
i just took off all clips screws on the front wheel weel and just pull down the front wheel well hard,cause the back wheel well is holding it from under.
when i did this install i check,try to learn how to get into the fog lights or hids..but didn't really figure it out...have no idea..i'm going to change the fog and hids next, can someone PM me the steps how to change the fog lights and change the hid lights? thx!

 

yea but where are all these clips can i reach them all without taking wheel

 

to do it with out removing the wheel...
u need a car jack!
jack it up...u will have more then enough space to do the install!
i did my fog in less then 15 mins each side
there is about 2 screws and 5 clips..i remember
then pull the liner down hard don't worry those stuff won't brake on u!

 

ooh! by the way..
make sure u have jack stand on the car before u put ur hands in!
be safe!

 

Yeah, you can just turn your wheel all the way towards the "inside" of the car, depending on which side you are changing.

The clips are circled in red. Screw is circled in yellow.

 

there is still one more screw that u cant see in the picture, BTW the two bottom clips in the first picture, u dont have to remover cause u can just peel it back with them on

Also all u have to do is jack up the car, i didnt even turn the wheel and there was still plenty of room to work w/

 

does "peeling" it back like bend it out of shape or anything

 

what bulbs did you use?

 

the liner is made out of plastic so its pretty durable, you can pull it all sorts of directions w/out breaking it, then all you have to do when you finish is to put it back in place so all of the clips can go in

 

You only need to undo that one screw. It also helps if you do this after you drive the car. The engine heat causes the plastic to be more pliable.

 

thx for the pics afro ill try it later