Interior & Exterior Exterior Modifications ; Interior Modifications ; Lighting ; Gauges and More

How do I remove the maplights/sunroofcontrol assy?

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old Dec 13, 2005 | 09:21 AM
  #1  
Nodnarb901's Avatar
Thread Starter
|
Registered User
Joined: Oct 2005
Posts: 129
Likes: 0
From: Memphis, TN
How do I remove the maplights/sunroofcontrol assy?

I am looking to remove this to hardwire my Valentine one, but cannot figure out how to remove the overhead map light/sunroof control/sunglass holder.
 
Reply
Old Dec 13, 2005 | 01:47 PM
  #2  
MISTIKMACK's Avatar
Registered User
Joined: Aug 2005
Posts: 1,084
Likes: 0
why dont u just hardwire it to your cig lighter. its very easy!
 
Reply
Old Dec 13, 2005 | 03:10 PM
  #3  
Nodnarb901's Avatar
Thread Starter
|
Registered User
Joined: Oct 2005
Posts: 129
Likes: 0
From: Memphis, TN
I'm wanting it under my rear view mirror so I will need to run the wire up through the headliner to get it down the A pillar, I would need to remove the maplight assy anyway right?
 
Reply
Old Dec 13, 2005 | 10:10 PM
  #4  
helldorado's Avatar
Registered User
iTrader: (4)
Joined: Apr 2005
Posts: 428
Likes: 0
From: NJ
Take a flat-head screwdriver and wrap it with a towel, the unit pops right out if you pry it. There are two prawls on the side facing you located in the middle of each light. Once you loosen the prawls and pop it out, you just have to disconnect the harness.

Shouldn't take you more than a minute.
 
Reply
Old Dec 13, 2005 | 11:12 PM
  #5  
Gordgee's Avatar
Administrator
iTrader: (64)
Joined: Jul 2002
Posts: 4,325
Likes: 4
From: Edmonton, Alberta, Canada
You can also hardwire directly into your wires going to the mirror.
 
Reply
Old Dec 14, 2005 | 09:03 AM
  #6  
dartmouth01's Avatar
Registered User
Joined: Nov 2005
Posts: 268
Likes: 0
Only if you have the homelink mirror though, AFAIK.
 
Reply
Old Dec 14, 2005 | 09:19 AM
  #7  
RaFmAn123's Avatar
Registered User
iTrader: (1)
Joined: Oct 2005
Posts: 192
Likes: 0
From: Searching for Signal.............
Thumbs up its not that complicated

when i installed my clifford pager alarm i had to put my antenna up there and its really simple to run the wire up where the roof meets the windshield you can pull down with your hand and stick the wire in the crack of the roof and run the wire all the way across to the left pillar the piller pops off by pulling the top and it will come off only clips hold it in then you can run the wire down and go to either ignition harness or cig lighter the cig lighter would be much more easier. if you go to harness you need to fuse it. when you cut the plug you dont need heavy gauge wires so it will fit nicely
 
Reply
Old Dec 14, 2005 | 10:47 AM
  #8  
Nodnarb901's Avatar
Thread Starter
|
Registered User
Joined: Oct 2005
Posts: 129
Likes: 0
From: Memphis, TN
Thanks for all the info, I will be wiring it today.
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
davizzle
Media Share G35 Coupe V35
23
May 22, 2022 09:26 AM
RemmyZero
V36 DIY
10
Apr 23, 2018 11:13 AM
davizzle
Video Share
5
Jan 31, 2017 04:00 PM
Extreme Dimensions
Southern California
3
Oct 19, 2015 06:28 PM
dcsbh1
Brakes & Suspension
0
Oct 1, 2015 03:15 PM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -4. The time now is 05:42 PM.