OFFICIAL: Aggressive Wheel fitment FLUSH/STRETCH sedan
Going to see if I can keep it at the same amount or even less. If I have to add camber, I don't think it will be much more. I have a good 15mm of clearance on the driver side I would say, perhaps more. The passenger side needs more pulling.
This whole time I've been trying to get the wheel to clear the fender and it's just not going to happen so I'm going to have it land as close to the rim as possible but on the outer portion of the tire. Gonna set up an appointment soon with Alex Pfeiffer soon to adjust the alignment and suspension after Monard and by buddy John help me out with a fender roll. I've mentioned it before, but Alex is a great guy to go to if you're in So Cal. He really hooks it up and that's who I've been going to for my suspension needs. If you haven't heard of him, type his name on youtube...pretty popular drifter....and his Lexus SC is nuts!
CRAP!!!!! Yeah that was a typo. My bad.... Fixed it it's 20x11 -12, so 18mm more aggressive.
This whole time I've been trying to get the wheel to clear the fender and it's just not going to happen so I'm going to have it land as close to the rim as possible but on the outer portion of the tire. Gonna set up an appointment soon with Alex Pfeiffer soon to adjust the alignment and suspension after Monard and by buddy John help me out with a fender roll. I've mentioned it before, but Alex is a great guy to go to if you're in So Cal. He really hooks it up and that's who I've been going to for my suspension needs. If you haven't heard of him, type his name on youtube...pretty popular drifter....and his Lexus SC is nuts!
Based on the pic below, should I go w/ a 15 or 10mm spacer up front? Have approx 2 finger gap currently vs approx 1 finger gap rear.
The wheel is slight turned but running a 225/40. Rear is 255/35 w/ 10mm spacer. Future plans will be moar low on coils and 245/35s all around. Tires are new so not going to drop that coin yet....
The wheel is slight turned but running a 225/40. Rear is 255/35 w/ 10mm spacer. Future plans will be moar low on coils and 245/35s all around. Tires are new so not going to drop that coin yet....
just dropped my car off at the shop getting some things done rear camber and spacers ... i went to get an alignment earlier and it was BAS NEWS !!!!! go stuck on the rack and had to use jacks to lift my car and roll LOL !! so i ended up taking the car to my buddies shop sine he has a low profile alignment rack that i never knew about and since its there might as well get work done ... i will be super flush very soon .. and ALL my polished things should be coming in this week as well ..
[/QUOTE]
