My bixenon projector retrofit
#32
#33
#36
Depends on how they had them configured. I have not found a way to bypass the bcm using the oem wiring and oem switches because when you turn on the hi the fog turns off. So if your using the fog as the low beam on the bixenon and turn the hi the solenoid will move but the light will shut off. I doubt they had them set up that way but could be wrong
#38
The way they had it setup was oem style. But now that i think of it i think ur right. I remember my fogs were turning off when i thrned my hi beams on. And the top would stay on. So how would that be any different? Sucks now that thats the case. Cuz the bixenon in trying to set up now is on the bottom.
#39
They didn't have the fog on the same projector as hi before. Now your trying to but it won't work. If your just trying for the single projector down low you will have to move the low to the bottom and have to lows and no fog or put the low/hi down low and make the top reflector the fog or run a seperate switch
#40
#41
From what I understand your running a single bixenon projector. That's really simple. Move the projector to the top. Make sure you get a d2s or dr2 projector is your using oem hid lights. The low beam will be as usual. On the bottom plug that goes on bulb you will cut the hi power and run it to the solenoid up top in the projector.
#45