Thanks! I was trying to avoid all the welding you did. Aluminum is more expensive than steel, but I think machining this single-piece design is better suited for "mass production."

 

Exactly! I had the same thoughts but we are so busy with other things...
Good Luck with your project!
Could be a good seller!!

 

I put my exhaust on the same way. Kinda cramped, but it gets the job done.

 

I'll take two for my 3 ton Harbor Freight jack stands.

Randy.

 

Sounds good, Randy! Can you measure the height of the sill on your car, that would fit into the stand adapter groove? It should be the same for the Infinity as my Maxima, but just to be sure.

I can of course make the groove deep enough to accommodate anything, but the deeper it is, the more material I have to use, and the more expensive the parts will be.

Alex

 

Just a little something that we came up with...
Anyone interested?? We may include the Jack Stands...

...thanks Zack, for the use of your G! lol

 

I will take four pm me info

 

i'm inn like flinn also, need some for my craftsman jacks. pm me info also please ktia!

 

Interested pm me

 

I'll take two. Thanks. Please PM me.

 

Nice! Are you talking about selling this one pair, or making more?

 

I'm interested as well!
I'd like to pick up 2!

 

Man Dave... look at this, aren't we overloaded as it is lol

Bump for some nice machining... he ran off to the shop with a piece of aluminum bar, and came back with these fittings a little while later. Great work as always!

 

You should offer both. For the people that have a set of jack stands already.

 

Good stuff Dave, when will you ever sleep