The Transformation of and Road to My VIP G35 Sedan
Registered User
iTrader: (10)
Joined: Jun 2006
Posts: 2,374
Likes: 14
From: Ladera Ranch / San Clemente
The bumper I'm keeping it on the low low....you've seen the photoshop 
but I wont have any pics till its complete. The audio, well, this is only the 1st setup I'll be doing. I'll probably go through 2 or 3, maybe 4. This is my budget setup. I just wish I didn't need to go the JDM double din route, otherwise I'd pick up an older Alpine double din (w200) and get the h701 processor and be set.
Thanks Rob
but I wont have any pics till its complete. The audio, well, this is only the 1st setup I'll be doing. I'll probably go through 2 or 3, maybe 4. This is my budget setup. I just wish I didn't need to go the JDM double din route, otherwise I'd pick up an older Alpine double din (w200) and get the h701 processor and be set.Thanks Rob
Dude I wanna hear the system...all those speaker pics makes me want subs again
Joined: Aug 2007
Posts: 10,850
Likes: 158
From: Los Angeles
Here's that clip of the muffler I just took...
Lol...I know, but I want it to be a surprise. I was hesitant to even show the fellas on the team.
Lol...I know, but I want it to be a surprise. I was hesitant to even show the fellas on the team.
Joined: Aug 2007
Posts: 10,850
Likes: 158
From: Los Angeles
Hearing your ride makes me want boost, period. lol.
Joined: Aug 2007
Posts: 10,850
Likes: 158
From: Los Angeles
Haven't done too much, but I've been getting some pretty neat ideas checking out some VIP mags. Anyhow, getting some JDM cigarette/ash tray holders...i don't smoke but they can be used as cupholders too. They'll match my table that I'm going to have made for me.
Also added some chrome trimmings to certain areas, I'll get pics of them if I can tomorrow.
Here's a temp pic of one of the JDM cup holders/ash tray....crappy cell pic.
Also added some chrome trimmings to certain areas, I'll get pics of them if I can tomorrow.
Here's a temp pic of one of the JDM cup holders/ash tray....crappy cell pic.
Joined: Aug 2007
Posts: 10,850
Likes: 158
From: Los Angeles
Added some chrome trimmings...also relocated the Garson hood badge to the trunk to cover up the holes 
. For the fenders, I messed up, but gonna redo, you can see one piece where I cut off the trimming and there was a gap so I put another piece there. Too lazy to take off and redo at the moment. The other side came out just fine though. Also some better pics of the cupholder.
. For the fenders, I messed up, but gonna redo, you can see one piece where I cut off the trimming and there was a gap so I put another piece there. Too lazy to take off and redo at the moment. The other side came out just fine though. Also some better pics of the cupholder.
