FS: SPL Compression Rod Bushings Pressed into OEM Arms Ready to install!
Joined: Mar 2009
Posts: 3,544
Likes: 150
From: Bremerton, Wa
SPL Compression Rod Bushings Pressed into OEM Arms Ready to install!
I have a set of SPL compression rod bushings already pressed into OEM compression rods. Ready to install.
I bought them thinking my OEM bushings were shot, but turns out they were fine.
Easy to install if you know how to turn a wrench.
READ: Please do your research as they are known to clunk as they are solid bushings. I installed them and the noise was just a little too much for my liking.
Asking for what I paid, $150 plus shipping.
Will also trade for a set of 20/25mm spacers or just show me what you have.
I bought them thinking my OEM bushings were shot, but turns out they were fine.
Easy to install if you know how to turn a wrench.
READ: Please do your research as they are known to clunk as they are solid bushings. I installed them and the noise was just a little too much for my liking.
Asking for what I paid, $150 plus shipping.
Will also trade for a set of 20/25mm spacers or just show me what you have.
Im interested. What's the condition of the ball joints and boots? Everywhere I read states that the Energy Suspension bushings don't allow for proper movement of the compression rod. Where as these SPL ones do. Is there really that much noise/clunking? It's hard to imagine them sqeaking and clunking more than OEM.
Thread
Thread Starter
Forum
Replies
Last Post
kinetek
Brakes & Suspension
9
Aug 3, 2015 04:25 PM
keithk831
Steering & Suspension
3
Aug 2, 2015 09:50 PM
