boo this doesnt fit with coilovers.

WHAT THIS DONT FIT TEIN BASICS? i was about to send the money TODAY@!?

i think the whole coil over fitment issue needs to be straightened out...i don't see how it cannot fit with coilovers. i think there may be a few sets of coilovers which the bar will not fit with...someone needs to clarify this

agreed..i have basics..i'm confused

for those who have basics...it does fit..I have basics on my car with the strut bar installed already...0 problems..again.IT WILL FIT WITH BASICS

thank you very much for this clarification....


the issue with the coilovers is that the dampening adjustment **** on some applications protrudes further upwards into the engine bay than others...since the mounts for the bar sit right above the same area, the dampening **** will obstruct the mounts...due to the various coilover applications available on the market, we have yet been able to confirm the fitment of the bar over all of the applications...

The basics uses the factory mounts so it shouldnt be an issue. But for anyone who have ..like u said richie the adjustable **** from other coilovers might have some issues.

It fits just fine with my Tein CS coils (with edfc motors).

Should Be Fine With All Tein

yea i have tien, i guess mines coming friday. hahha

i have been reading a bit back in this post....this seems to fit the tein Flex,,, im sure if you have the older stepping motors on the tein flex you might have a problem... the newer rubber covered style is smaller in design and may be the ones that are ok.. i have the newer style anyway... but im still bumming i have a Vortech setup looks like its not confirmed to fit... otherwise id be sending my cash too..

vortech has been confirmed...i will hopefully have mine on by this weekend and i'll post pics

Just so everyone knows, this works with a 5/16" MD spacer, the engine cover and the JWT TT kit. All at the same time!

Dave

i found 140 in my paypal account so i just placed my order.

payment sent