Ok I was trying to be a good teamate so me and Ronnie switched spacers so ronnie could put his stock strut bar back on his 350Z...I gave him my Mtrdyn 5/16 and ge gave me his AAM angled spacer...I intalled the spacer last night and the car runs perfect and everything except at idle...it will idle at about 750-800 rpm which is what it was idling at before w the 5/16...but every 30 seconds the rpms dip down to about 600 and the car almost dies...the computer will self adjust and the idle goes back up to 750-800...I left the battery disconnected overnight...any ideas on how to fix the idle? I double check all bolts and hoses and everything appears to be in order...

 

have you tried resetting the ECU using the foot dance method??? Im not sure if disconnecting the battery clears the ECU completely... just my.02

 

i think the computer just has to relearn. i dont think its anything big. make sure your battery is good. my battery f@wk up my butterfly position and was making my car run super lean and stall out. so i had to get a new battery and get my throttle position retuned. my car idles real low due to my clutch and flywheel.

 

No I havent...it that the deal that came w the Mtrdyn pprwrk?

 

Well I tried to reset my throttle body w the instructions off of Motordyne but I just can't do it...I can't get the cel to blink...it just comes on and stays on when I depress the accelrator 5 times w/in 5 seconds...Devin, I need your boy to set it for me asap please!