The rubber weather trim around my door keeps popping out from the top portion above the window. What tool or method do you guys use to put it back into place? The rubber has wedges bult into it, but Im having trouble getting it back into the grooves around the door.

 

I had the same problem, I just went to the body shop down the street from my house and had them put it back on. They just charged me $10 bucks to glue it back, the shop is out here in Canoga Park. I am sure any body shop can put it back on for cheaper than that. If not hit me up and I can give you the address of the shop here.

 

No need to glue it on. Just take off the strip from the beginning at the tip of the window until you reach the area where the strip popped off. Then reinstall it by installing the strip into the lower groove first and then the upper, Keep doing this (lower then upper, lower then upper, etc) until you reach the tip of the window and just snap it back in place. It's kinda hard to explain sorry if it's not clear what I meant.

 

^ +1
That's about as clearly as one could explain it man, good job. lol

 

Crazy! I just popped mine back in on my left passanger side.. I did notice that would only pop in half of the way on the top portion.

 

The dealership could likely affix the weatherstripping too, there's a TSB out and I had mine worked on earlier last year

 

i just used a flathead screwdriver to pop it back in place. worked perfectly.