Offsets
#1
Offsets
I have a 2004 G35 coupe 6mt and I was thinking about putting 20 inch rims on it and I want them to be flush with the fender, not sunken in like the stock wheels are but I don't want it to be possible to hit the fender if I hit a dip. I was looking at a set that 30mm offset in the front and 35mm offset in the back.
Last edited by JCapstick; 03-31-2009 at 02:43 AM.
#2
Former G35driver Vendor
iTrader: (84)
you have to take widths into account when calculating where the wheel is gonna sit, not just an offset.
Are you willing to roll your rear fenders? I hope so, that'll give you a better chance at getting flush, you WILL NOT be flush without rolling your fenders plain and simple.
Post what widths you're looking to run and we can give you a better idea of the offsets!!!
Are you willing to roll your rear fenders? I hope so, that'll give you a better chance at getting flush, you WILL NOT be flush without rolling your fenders plain and simple.
Post what widths you're looking to run and we can give you a better idea of the offsets!!!
#3
#7
hey go to www.rims-n-tires.com and put in 04 g35 coupe and look at the MSR 93 B
I ordered them with perelis
I ordered them with perelis
Trending Topics
#13
whether its a big deal or not depends on you.. if it bothers you and you want to make the wheels flush with your fenders, get 15mm spacers up front and 20mm in the rear. To get it flush and not have your tires rub, you would need to roll your fenders. ShanesG does fender rolling so if you're in so cal.. shoot him a pm to get it done.