i'm on oem 19s too.

das fitment. front fender is pulled a bit.







you can see the clearance up front. camber is at -7 though.

I look like a fool driving around like this. the rear fitment looks like a donut.

 

oh, there's a 30mm spacer up front.

 

im sure its not your plan to keep them for good ,but they might be my favorite setup on your car so far. not fitment wise obv lol but just lookin at the potential they have, dunno why- they just work.
you wont get them widened

 

Yeah the OEM 19s do not look bad. If the fitment wasn't so retarded looking on my car (my car looks like it's floating from the back), I would roll on them so I can stop wasting money on wheels.

 

Yeah thatd get old. Thanks homie. I'll post up a pic once it's dropped

 

LOL! Damn Toretto, I didn't realize you're fenders were pulled that much...

The Rays do look good on the G, just wish Nissan made the fitment a little better, in general.

- DM

 

Question about sway bar settings. I got some hotchkis. Any preferred settings for the "stance" crowd? Or does it matter.

 

dont think it matters

 

Get them widened, space them out and run oem camber..

 

i'd rather get some TE37s widened to 19x12

 

I want Meisters.
No one asked. But I'm telling whoever wants to listen.

 

did big booty trudy get wheels yet

 

Nut shore

 

20 x 10.5 +27 with 275/30R20 all round on a 03 coupe. I will be on a 2inch drop front and rear (springs & z shocks).

Might run spacers in the rear if needed so the rears dont look sunk in comparison.

Anyone done this? Will it work? Or look mexi as ****?

Cheers.

 

yeah it'll work.