Does anyone know if these hub centric rings will work on the 526s?

http://www.ebay.com/itm/73-1-66-1-mm...d7e428&vxp=mtr

 

They do. The center bore on the whees is 73.1mm and the hub bore on the car is 66.1mm Can't wait to get these in woot!

 

Why are you so excited to put on hubcentric rings?? Lol

 

I already have one stripped stud that I have to replace and I don't want to eff up my new purple lugnuts lol

 

I had a question and yes, i have been doing a lot of research....currently im lowered on tein s-techs (z) with the rear springmount mod running my oem rays with a 20mm spacer in the front and 25mm spacer in the rear. i recently ordered some xxr 526 wheels 20x9+13 f and 20x11+13 r. I am planning on swapping the spacers (put the 25mm up front and 20mm on the rears) and i will be running 225/35 f and 255/35 rear for some stretch. I will be getting my fenders rolled, my question is will I need to roll my fronts as well due to the spacers and will I even be able to run that setup with those spacers without a fender roll AND pull? Im trying to avoid a pull. I have been doing a lot of research and I see people have run 20mm spacers in the rear with just a pull and 25mm up front but im not sure if that person had a pull up front as well (saw it on 2 diff cars). I was also thinking about leaving the spacers as they are now with the 526 wheels but don't know if that's too much as I can't find anyone that has 25mm spacers on the rears with that width and offset. I want an aggressive look but I don't want to have rubbing issues as it is my daily driver in San Diego. oh, and I will also be running pretty much normal camber with no camber kit. any help would be appreciated, thanks.

 

Your tire sizes are good. I would take your car to the fender roller, slap the spacers on and roll/pull to fit. Worst case is to get smaller spacers if you aren't happy

 

With spacers up front, you will need a roll but probably not a pull. For the rear, if you run spacers, you will definitely need a pull.

Here's a few pictures of my car with G37 S-Techs so I'm not as low as you are with the Z S-techs and I don't have spacers.

 

Are those 20x11 +15 or +13?

 

And do you have your rears rolled?

 

+13. Fronts are not rolled but rears need to be. I can't drive it until I get them rolled.

 

looks like you need negative camber my friend, that drop isn't aggressive at all

 

Yeah I know.

 

Old thread, but I'm seeing these XXR 527 forged wheels. 18x9 +35 for about $1600. Should fit a RWD sedan nicely, no? I like look, and it seems to be a good price for forged wheels. Anyone have these?

 

They'll definitely fit. I like them a lot and I don't think I've ever said that about any XXR wheel.

 

XXR Forged?