Hi All,

A month and a half ago i had the following installed by a shop: Coil overs, spc camber kit, new tires. My mechanic had the tires mounted and balanced and supposedly they did 4 wheel alignment.

Now all the tread on my rear tires have no tread. My mechanic swears that its most likely the guys who did the alignment but he took it back to them and they found nothing wrong.

Does anyone have another ideas how i ran through my tires so fast?

How is this possible, lol.. Do u check your air pressure regularly?? Do a lot of burn outs?? U check all your bushings and such??

Toe was out of wack..How low are you?

passenger side

wtf? positive camber? lol its the toe

The air pressure in the tires is fine, I haven't done any burn outs and i haven't checked any bushings =/

I'm not very low at all probably about 6 inches off the ground but i'm not sure. i'll measure later

So what should i do?

What tires did you get installed? This is hard to believe that you those tires are THAT worn out in one month.

Do you have the alignment print out?

Hankook Ventus V12 evo K110 XL

I had the same tires on for two years with negative camber so i was surprised that these tires wore after a month.

No... the shop my mechanic went too doesn't give out print outs...

fyi the shop that did my alignment is Bridges Tire & Wheel Service

http://www.yelp.com/biz/bridges-tire...ice-burlingame

Id cause hell up in the shop but first try it politely. New tires like that in 1 month, somebody did not do there job right.

So its definitely the alignment then?

Are the tires cupped at all? If so, I would lean towards toe. If not, I would lean towards camber.

The tires are not cupped, they are now slick all the way around